FMB202 Installation instruction

From Wiki Knowledge Base | Teltonika GPS
Revision as of 15:26, 2 May 2019 by Donatas.Andriulionis (talk | contribs)

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)
Main Page > Advanced Trackers > FMB202 > FMB202 Manual > FMB202 Installation instruction

Possible mounting zones

Trucks

It is strongly recommended to mount FMB202 outside of the vehicle with the sticker direction to the sky.
Trucks.png


Most commercial trucks have plastic hood in front of the vehicle. It is recommended to mount FMB202 under the hood. Power cord output of the device should be at the bottom. If it is not possible, if a front hood is made of some kind of metal, the device can be mounted inside the car on the front panel as close as possible to the front window.
Truck Inside.png


Tractors

It is strongly recommended to mount FMB202 outside of the vehicle with the sticker direction to the sky.
Tractors.png

Motor bikes

FMB202 device should be mounted on outside.
Possible mounting places for motorbikes.png


FMB202 cannot be mounted under the seat!
Not mount device under seat.png

Light vehicles

Most light vehicles has oblique front window that opens most part of interior front panel. FMB202 can be mounted under the plastic panel behind the front window, with the sticker direction to a window (sky).
Light Vehicles.png

Recommended mounting positions

Best FMB202 mounting position is outside of vehicle with any metal above the device. Recommended deviation from horizontal axis of vehicle max 3-5°.
Mounting positions.png


Mounting position and recommended deviation from longitudinal axis of vehicle ±2°.
Mounting positions v2.png

Restrictions

FMB202 device can not be mounted inside in the vehicle door!
Inside door.png


FMB202 device cannot be mounted inside the vehicle!
Inside vehicles.png

Connecting power wires

  1. Device should be connected directly to battery. Power supply: 6V/12V/24V.
  2. If FMB202 is used in 6V system and power cables are extended.

Extension cable resistance should be less than 60 mΩ in sum of both, positive and negative, wires. 30 mΩ for single wire.
FMB2YX connection to the car circuit.png