FMC640 Trip/Odometer settings

From Wiki Knowledge Base | Teltonika GPS
Revision as of 13:56, 2 September 2019 by Irmantas.Tydikas (talk | contribs) (Protected "FMC640 Trip/Odometer settings" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite)))

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)
Main Page > EOL Products > FMC640 > FMC640 Configuration > FMC640 Trip/Odometer settings

Trip Settings

Fmb640 trip settings.png

Trip window offers user to configure Trip feature. Trip customizable feature enables user extended monitoring of performed trips (from engine start at present location to engine stop at arrived location), log their start and stop points, view driven total distance. Event will be generated (included into send records) only when trip starts and finishes. Start Speed (km/h) – GPS speed has to be greater than the specified Start Speed in order to detect Trip Start. Ignition OFF Timeout (s) – timeout to wait if ignition (configured ignition source) was off, to detect Trip stop. Distance counting mode – Between Records or Continuous can be chosen. For this feature I/O Trip Odometer must be enabled. If I/O Trip Odometer is enabled and Continuous distance counting variable (Mode) is set to Continuous, Trip distance is going to be counted continuously (from Trip start to Trip stop). This value is written to I/O Trip Odometer value field. When Trip is over and next Trip begins, Trip Odometer value is reset to zero. When the next trip starts counting continuously starts from the beginning again. If I/O Trip Odometer is enabled and Continuous Distance Counting variable (Mode) is set “Between Records”, then the distance is going to be counted only between every record made. This value is written to I/O Trip Odometer value field and reset to zero every new record until Trip stops. If later all Odometer values are summed up manually, the user gets the distance driven during the whole period of the Trip.

Fmb120 trip mode.png

Advanced Trip Settings

Fmb640 advtrip settings.png

Remember iButton functionality. If Remember iButton and Trip parameters are enabled, ignition is on and iButton is attached then FMC640 remembers iButton ID. iButton ID is saved and sent to the server with every record. If new iButton is attached during the Trip, FMC640 remembers new iButton ID. FMC640 forgets iButton ID after ignition is off and ignition timeout is reached.