729
edits
Changes
FMx6 and Tachograph Solution (view source)
Revision as of 15:45, 17 April 2023
, 15:45, 17 April 2023→Remote Data Download (RDD) via FMS
* Volvo FH - FM - FL
* Volvo FH - FM - FL
If the '''RDD''' signal is available on the '''FMS''' interface, no additional connection is required. In this case, the '''CANx LOW and HIGH''' wires from the FMx640 are connected to '''PIN 6 and 9''' on the '''FMS''' connector.
If the '''RDD''' signal is available on the '''FMS''' interface, no additional connection is required. In this case, the '''CANx LOW and HIGH''' wires from the FMx6 are connected to '''PIN 6 and 9''' on the '''FMS''' connector.
Additionally, '''PIN 10''' can be used for ignition detection using '''DIN1''' wire.
Additionally, '''PIN 10''' can be used for ignition detection using '''DIN1''' wire.
*CAN wire needs to be installed as far as possible from the GSM antenna.<br />
*CAN wire needs to be installed as far as possible from the GSM antenna.<br />
Below is a wiring diagram of the Tachograph and FM6400/FMx6 device:<br />
Below is a wiring diagram of the Tachograph and FMx6 device:<br />
[[Image:Wiring_diagram.PNG|800px|center]]
[[Image:Wiring_diagram.PNG|800px|center]]
