How to install FMM640 to MB Actros

Main Page > EOL Products > FMM640 > FMM640 Manual > How to install FMM640 to MB Actros
800px-1 FMX640 and MB actros.png

Installation proccess

  • Below is shown main installation location:
  • Main cables, which should be used – twisted pair of violet and white-brown for FMS/CAN and Tachograph connection. The same line is used to read FMS data and to download Tachograph files. Additionally, K-line wire for live vehicle data from the tachograph is located in the same place violet – white wire:
  • Below shown the connection of CAN1 pair from FMB6 device to FMS/TACHO line on vehicle and K-line connection to FMB6:
  • To get proper resistance on the CAN circuit, needed to disconnect the resistance connector which is near the tachograph:

  • Recommended power source and ignition connection wires:

More detailed view of Ignition connection:

  • Recommended place for GNSS antenna:

After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if the installation is properly made. Turn on the ignition of the vehicle and send SMS command: “tachocheck”. If the response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.