139
edits
Changes
mLine 49:
Line 49: + Line 81:
Line 82: + Line 86:
Line 88: − + − − − Line 97:
Line 96: − − − Line 107:
Line 103: − −
no edit summary
If the firmware version is lower than 1.3, it is necessary to update the device.
If the firmware version is lower than 1.3, it is necessary to update the device.
'''1. Updating NBL-2'''
'''1. Updating NBL-2'''
7. Correct firmware update will be signaled by device start-up led message.
7. Correct firmware update will be signaled by device start-up led message.
To set factory defaults and un-pairingboth buttons must be pressed for 5 seconds additionally button 1 (blue) must be pressed first. It is also factory/transport configuration.
To set factory defaults and un-pairingboth buttons must be pressed for 5 seconds additionally button 1 (blue) must be pressed first. It is also factory/transport configuration.
Procedure:
Procedure:
# Press Button1 and hold
# Press Button1 and hold
# Press Button2 and hold
# Press Button2 and hold
'''3. Power ON (After Powered OFF)'''
'''3. Power ON (After Powered OFF)'''
Procedure:
Procedure:
# Press Button 2 and hold
# Press Button 2 and hold
# Keep the button pressed for 5 seconds
# Keep the button pressed for 5 seconds
'''3. Paring'''
'''3. Paring'''
When device have defaults settings, reader waits for button then sends advertising packet for 50 seconds and blinks LEDs. First connection in this state is pairing process. Paring mode used: No Pin.
When device have defaults settings, reader waits for button then sends advertising packet for 50 seconds and blinks LEDs. First connection in this state is pairing process. Paring mode used: No Pin.