139
edits
Changes
mLine 75:
Line 75: − + Line 82:
Line 82: − − + Line 96:
Line 95: + Line 119:
Line 119: − + Line 253:
Line 253: − +
no edit summary
[[File:NBL conf7.jpg.jpg|frameless|520x520px]]
[[File:NBL conf7.jpg.jpg|frameless|520x520px]]
5. Wake up the device - eg entering it into the bootloader mode.
5. Wake up the device - for example, by applying a card to it.
6. Select the device from the list (long press), then select Update firmware from the drop-down menu and press the Start button.
6. Select the device from the list (long press), then select Update firmware from the drop-down menu and press the Start button.
7. Correct firmware update will be signaled by device start-up led message.
7. Correct firmware update will be signaled by device start-up led message.
'''2. Power OFF /Reset to default settings'''
'''2. Power OFF /Reset to default settings'''
To set factory defaults and un-pairingboth buttons must be pressed for 5 seconds additionally button 1 (blue) must be pressed first. It is also factory/transport configuration.
To set factory defaults and un-pairingboth buttons must be pressed for 5 seconds additionally button 1 (blue) must be pressed first. It is also factory/transport configuration.
Procedure:
Procedure:
# Press Button1 and hold
# Press Button1 and hold
'''3. Power ON (After Powered OFF)'''
'''3. Power ON (After Powered OFF)'''
Procedure:
Procedure:
# Press Button 2 and hold
# Press Button 2 and hold
Then go to I/O settings:
Then go to I/O settings:
Make sure to enable the BLE RFID #1 parameter (ID: 51740) and set the operand to „On Change“.
Make sure to enable the BLE RFID #1 parameter (ID: 51740). We would recommend to set the operand to „On Change“.
[[File:Nbl2 3.png|frameless|999x999px]]
[[File:Nbl2 3.png|frameless|999x999px]]
|-
|-
|CID
|CID
|ID card number.
|ID card number
|}
|}
|21B
|21B