Template:FM3 System settings

From Wiki Knowledge Base | Teltonika GPS
Revision as of 13:34, 30 May 2018 by Mantas.slipaitis (talk | contribs)

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)

System settings have following configurable parameters:

  • Sleep Settings, where user can choose sleep mode;
  • Ignition Source, where user can choose an ignition source from power voltage and accelerometer. More than one ignition source can be selected at the same moment. User can select movement start and movement stop delay time - those parameters are used when accelerometer is selected as an ignition source. Ignition status is used in power management and the following functionalities: eco driving, excessive idling, fuel consumption, over speeding, towing and trip;
  • Object motion detection settings, where user can configure 3 ways how FM3001 detects movement and change its working mode (for more information refer to section FM3001 Data acquisition settings). Other functionalities that depend on movement source are: power manager, fuel consumption and trip;
  • Static Navigation Settings, where user can turn static navigation on or off. Additionally, user can choose which source (movement or ignition) is used to activate/deactivate static navigation;
  • Records settings (no time synchronization), where user can enable or disable records when GPS is not available;
  • GNSS Source settings, where user can choose the necessary satellite system(s);
  • LED Indication, where user can turn on or off the indication LEDs;
  • Battery Charge Mode, where user can choose when battery will be charged: On Need (battery will be charged anytime when it needs to be charged) and After Ignition ON (battery will be charged only when ignition is on);
  • Time Synchronization settings, where user can choose which source(s) to use for FM3001 time synchronization. User has a choice to: use only one synchronization source (Disable (GPS only)), allow synchronization from both the GNSS and NTP server (NTP), select synchronization through GNSS and GSM operator (NITZ) or from all three sources (when NITZ+NTP is selected). User can select which NTP server (it is possible to configure up to two servers) and what time period to use to resynchronize time.

Static Navigation mode is a filter, which filters out track jumps when the object is stationary. If static navigation filter is disabled, it will apply no changes to GPS data. If static navigation filter is enabled, it will filter changes in GPS position if no movement (as defined by configured movement source) or ignition (as defined by configured ignition source) is detected. It allows filtering GPS jumps when the object is parked (not moving) and GPS position is still traced.

FM3 System.png

In GNSS Source settings user can configure which GNSS system(s) to use.
User has a choice to use only one system between GPS, GLONASS, Galileo or Beidou and it is possible to choose two or three systems together. One exception is that you cannot combine BeiDou and GLONASS systems together. Examples of non-configurable GNSS source combinations are:

  • GLONASS + BeiDou;
  • Galileo + GLONASS + BeiDou;
  • GPS + GLONASS + BeiDou;
  • GPS + Galileo + GLONASS + BeiDou.
Selected source(s) ID
BeiDou only 01
GLONASS only 02
Galileo only 04
Galileo + Beidou 05
Galileo + Glonass 06
GPS only 08
GPS + BeiDou 09
GPS + Galileo 12
GPS + Galileo + BeiDou 13
GPS + Galileo + GLONASS 14