Changes

no edit summary
Line 1: Line 1:  
[[Image:Qsg_rut950_teltonika.PNG|centre]]
 
[[Image:Qsg_rut950_teltonika.PNG|centre]]
   −
<b>{{{description|Small and smart tracker with Blue-tooth}}}</b>
+
<b>{{{description|Small and smart tracker with Bluetooth®}}}</b>
 
{{{pic|[[Image:Fmb920 main.png|400px|right]]}}}
 
{{{pic|[[Image:Fmb920 main.png|400px|right]]}}}
 
<br>
 
<br>
Line 11: Line 11:  
=='''How to insert Micro-SIM card'''==
 
=='''How to insert Micro-SIM card'''==
   −
*Insert Micro-SIM card as shown with PIN request disabled or
+
{{{without_battery|
read our Wiki how to enter PIN later in Teltonika
+
# Gently remove {{{model|FMB9YX}}} '''cover''' using '''plastic pry tool''' from both sides.
Configurator. Make sure that Micro-SIM card cut-off corner is
+
# Insert '''{{{sim_type|Micro-}}}SIM''' card as shown with '''PIN request disabled''' or read {{{sim_pin|[[{{{model|FMB9YX}}} Security info|'''Security info''']]}}} how to enter it later in Configurator. Make sure that {{{sim_type|Micro-}}}SIM card '''cut-off corner''' is pointing forward to slot.
pointing forward to slot.
+
# Attach device '''cover''' back.
*Connect battery as shown to device.
+
# Device is ready to be connected.}}}
*Connect micro usb cable as shown
  −
*To power up TST100, connect green plug to the E-scooter
  −
*Open Teltonika configurator, select TST100 device and
  −
configure it according to your requirements (how to install
  −
drives on page
  −
*Once all done, disconnect TST100 from PC and E-scooter. Attach
  −
the lid by two screws as shown
     −
[[Image:Sim_1.png|280px]][[Image:Batt_2.png|280px]][[Image:Usb_3.png|280px]][[Image:Screw_4.png|280px]]
+
{{{with_battery|
 +
# Gently remove {{{model|FMB9YX}}} '''cover''' using '''plastic pry tool''' from both sides.
 +
# Insert '''{{{sim_type|Micro-}}}SIM''' card as shown with '''PIN request disabled''' or read {{{sim_pin|[[{{{model|FMB9YX}}} Security info|'''Security info''']]}}} how to enter it later in Configurator. Make sure that {{{sim_type|Micro-}}}SIM card '''cut-off corner''' is pointing forward to slot.
 +
# Connect the battery as shown on device. Position the battery in place where it does not obstruct other components.
 +
# Attach device '''cover''' back. Device is ready to be connected.}}}
 +
 
 +
{{{SIM1|[[Image:FMB9_sim_ir_battery_insert-1.png|260px]]}}}
 +
{{{SIM2|[[Image:FMB9_sim_ir_battery_insert-2.png|260px]]}}}
 +
{{{SIM3|[[Image:FMB9_sim_ir_battery_insert-3.png|260px]]}}}
 +
{{{SIM4|[[Image:FMB9_sim_ir_battery_insert-4.png|260px]]}}}