Template:FMM640 Trip/Odometer settings

From Wiki Knowledge Base | Teltonika GPS
Revision as of 15:09, 22 August 2019 by 212.59.13.226 (talk) (Created page with "==Trip Settings== 250px|right Trip window offers user to configure Trip feature. Trip customizable feature enables user extended monitorin...")

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)

Trip Settings

Fmb640 trip settings.png

Trip window offers user to configure Trip feature. Trip customizable feature enables user extended monitoring of performed trips (from engine start at present location to engine stop at arrived location), log their start and stop points, view driven total distance. Event will be generated (included into send records) only when trip starts and finishes. Start Speed (km/h) – GPS speed has to be greater than the specified Start Speed in order to detect Trip Start. Ignition OFF Timeout (s) – timeout to wait if ignition (configured ignition source) was off, to detect Trip stop. Distance counting mode – Between Records or Continuous can be chosen. For this feature I/O Trip Odometer must be enabled. If I/O Trip Odometer is enabled and Continuous distance counting variable (Mode) is set to Continuous, Trip distance is going to be counted continuously (from Trip start to Trip stop). This value is written to I/O Trip Odometer value field. When Trip is over and next Trip begins, Trip Odometer value is reset to zero. When the next trip starts counting continuously starts from the beginning again. If I/O Trip Odometer is enabled and Continuous Distance Counting variable (Mode) is set “Between Records”, then the distance is going to be counted only between every record made. This value is written to I/O Trip Odometer value field and reset to zero every new record until Trip stops. If later all Odometer values are summed up manually, the user gets the distance driven during the whole period of the Trip.

Fmb120 trip mode.png