Changes

**For better contact scrub paint from the spot where loop is going to be connected.

**For better contact scrub paint from the spot where loop is going to be connected.

}}}

}}}

{{{pay_attention|{{Template:Pay_attention|model={{{model|FMB2YX}}}}}}}}

{|-

| [[File:Alert.png|left|link=]] || <b>PAY ATTENTION! Connecting the power supply must be carried out in a very low impedance point of on-board vehicle network. These points in the car are the battery terminals. Therefore, we recommend connecting the power of device (GND and POWER wires) directly to the battery terminals. Another valid option is to connect the wires to the main POWER cable inside the fuse box (if there is none, then to the power supply where the fuses of vehicle’s computer are), GND wire must be connected in a special point, designed to connect GND vehicle computer. Connecting the GND at an arbitrary point to the mass of the car is unacceptable, as static and dynamic potentials on the line GND will be unpredictable, which can lead to unstable device operation and even its failure.</b>

|}

}}}

}}}