Line 1: |
Line 1: |
− | Wiki.
| + | == Struggle after upgrading CAN-CONTROL to CAN-CONTROL+Immobilizer? == |
− | FAQ
| + | Possible encounters after upgrading CAN bus adapter: |
| | | |
− | Upgrading CAN-CONTROL to CAN-CONTROl+Immobilizer
| + | * Vehicle doors Lock/Unlock is not working; |
− | <br>
| + | * Vehicle doors Lock/Unlock is working but engine Blocking/Unblocking does not and after sending commands, the response is: "''CAN-CONTROL cmd not supported''". |
− | Possible problems:
| |
− | <br>
| |
− | 1. Doors Lock/Unlock is not working.<br>
| |
− | 2. Doors Lock/Unlock works but engine blocking and unblock does not. Most of times response will be: CMD not supported. In some situations engine block will work but unblocking will not.<br>
| |
− | <br>
| |
− | After installation is done and program number is set please do learning procedure.
| |
− | <br>
| |
− | 1. send lvcansetprog 11120 (Or any other) <br>
| |
− | 2. send lvcansetprog (one that is for your car model)<br>
| |
− | 3. After you will receive response please do learning with key locking/unlocking 3 times. lock>unlock;lock>unlock;lock>unlock;
| |
− | <br>
| |
− | Now you can try commands to open and close doors.<br>
| |
− | Now you can try commands to block and unblock engine.<br>
| |
− | <br>
| |
− | All sms/gprs responces should inform you that command has been completed succesffully.<br>
| |
| | | |
− | Note: If installing CAN-CONTROL adapter into different vehicle learning must be initiated. If adapter will be installed back on previous car model learning step must be repeated.<br> | + | If You encounter with any of these issues - follow solution steps below. |
| + | |
| + | == Solution == |
| + | After installation is completed and CAN bus adapter program is set, please, follow these steps: |
| + | |
| + | # Do a learning procedure - using the vehicle key, unlock and lock vehicle '''three''' '''times'''; |
| + | # Send GPRS command - " lvcansetprog 11120" (or any other). Program number must contain 5 digits. |
| + | # Send GPRS command - " lvcansetprog ''the one that is for Your vehicle model''". Program number can be seen in at the top of the CAN adapter connection scheme. |
| + | # After receiving a response to a command, repeat the learning procedure (first step). |
| + | |
| + | |
| + | {| |
| + | |- |
| + | | [[File:Alert.png|left|link=]] || <b>'''Note''': Before SMS text, two space symbols should be inserted if no SMS username or password was set in [[FMB001 SMS/Call settings|SMS / Call settings]]. |
| + | After completed these steps, commands to open/close and to block/unblock engine can be performed. |
| + | All SMS/GPRS responses should inform You that particular command has been completed successfully.</b> |
| + | |} |
| + | |
| + | <bR> |
| + | {| |
| + | |- |
| + | | [[File:Alert.png|left|link=]] || <b>'''Note''': if installing CAN-CONTROL adapter into different vehicle - program should be changed according to the vehicle model and learning must be initiated ("first solution step"). |
| + | If adapter will be installed again on the previous vehicle - program number needs to be restored and learning step must be repeated. |
| + | </b> |
| + | |} |