How to capture CAN adapter log from FMB1YX?

From Wiki Knowledge Base | Teltonika GPS
Main Page > Fleet management > Fleet management FAQ > How to capture CAN adapter log from FMB1YX?

Solution applies for these devices

FMB110 FMB120 FMB122 FMB125 FMB140

Here are steps how to capture LV-CAN200, ALL-CAN300, CAN-CONTROL log from FMB1YX series devices.

This functionality is available after 03.08.00 firmware version.

  1. Make sure that CAN adapter is connected properly to the vehicle and to FMB1YX series device.
  2. Start vehicle engine.
  3. Send following SMS command to FMB1YX device:
    • If you have set SMS login and password: login pass log2sdfilterset 4
    • If SMS login and password are not set leave two spaces before command: aalog2sdfilterset 4

      If command was sent correctly you should receive SMS Response:Enabled Trace Filters:1

  4. After SMS response message CAN adapter log capturing has been started.
  5. Wait at least 5 minutes to get enough CAN bus data and turn off vehicle engine.
  6. Download captured log (dump) files.
    • Using Teltonika Configurator

      Please check Status info→Maintenance→Log/Dump and download dump YYYY_MM_DD_HH_MM_SS_FMB1YX_IMEI_Dump.zip.

    • Using FOTA WEB

      Enter FOTA WEB→Press on Devices tab→Select your device and press Fota actions.pngDownload from deviceContinuous log files (2) (2 files. Each log size up to 1 MB)→Fota download.png. To start download process at once send following SMS command:

      • If you have set SMS login and password: login pass web_connect
      • If SMS login and password are not set leave two spaces before command: aaweb_connect

        If command was sent correctly you should receive SMS Response:web_connect resp:OK

        To find downloaded log press on device Fota moreinfo.png icon→Go to CONT.LOGS tab→Download IMEI_TIMESTAMP.zip

  7. After you have downloaded log files send following SMS command to FMB1YX device:
    • If you have set SMS login and password: login pass log2sdfilterset 0
    • If SMS login and password are not set leave two spaces before command: aalog2sdfilterset 0

      If command was sent correctly you should receive SMS Response:Enabled Trace Filters:1

  8. These log (dump) files can be read only with special software. Provide these files to your Teltonika Sales manager or Teltonika Support team for further investigation.