Difference between revisions of "Template:FMB9 First start card"

From Wiki Knowledge Base | Teltonika GPS
Line 31: Line 31:
 
| [[File:Alert.png|left|link=]] || <b>{{{sim_type|Micro-}}}SIM card insertion/removal must be performed when device is powered off – external voltage {{{battery|and internal battery}}} disconnected. Otherwise {{{sim_type|Micro-}}}SIM card might be damaged or device will not detect it.</b>
 
| [[File:Alert.png|left|link=]] || <b>{{{sim_type|Micro-}}}SIM card insertion/removal must be performed when device is powered off – external voltage {{{battery|and internal battery}}} disconnected. Otherwise {{{sim_type|Micro-}}}SIM card might be damaged or device will not detect it.</b>
 
|}
 
|}
 
=='''How to insert microSD card'''==
 
 
# Push microSD card lock case.
 
# Open microSD card locker.
 
# Correctly insert microSD card into slot.
 
# Close microSD card locker.
 
# Push microSD card lock case to locked position.
 
 
<b>NOTE:</b> SD cards are only used in devices manufactured until '''2018-04'''. Newer devices have internal flash memory.
 
 
[[Image:Sd_card_1.png|x150px]] [[Image:Sd_card_2.png|x150px]] [[Image:Sd_card_3.png|x150px]] [[Image:Sd_card_4.png|x150px]] [[Image:Sd_card_5.png|x150px]]
 

Revision as of 07:03, 6 May 2019

Qsg rut950 teltonika.PNG

Small and smart tracker with Blue-tooth

Fmb920 main.png




How to insert Micro-SIM card

  • Insert Micro-SIM card as shown with PIN request disabled or

read our Wiki how to enter PIN later in Teltonika Configurator. Make sure that Micro-SIM card cut-off corner is pointing forward to slot.

  • Connect battery as shown to device.
  • Connect micro usb cable as shown
  • To power up TST100, connect green plug to the E-scooter
  • Open Teltonika configurator, select TST100 device and

configure it according to your requirements (how to install drives on page

  • Once all done, disconnect TST100 from PC and E-scooter. Attach

the lid by two screws as shown

Sim 1.pngBatt 2.pngUsb 3.pngScrew 4.png


Alert.png
Micro-SIM card insertion/removal must be performed when device is powered off – external voltage and internal battery disconnected. Otherwise Micro-SIM card might be damaged or device will not detect it.