Wiki Knowledge Base | Teltonika GPS

Changes

How to check available OBDII data? (view source)

Revision as of 16:16, 2 April 2019

99 bytes added ,  16:16, 2 April 2019
no edit summary
Line 1: Line 1:  
To check or OBD data is available from OBD device, please do the following:  
 
To check or OBD data is available from OBD device, please do the following:  
−
1.Send to device the command obdinfo.  
+
#Send to device the command [https://wiki.teltonika-gps.com/view/FMB_obdinfo obdinfo]. Response details:
−
Response details:
+
Returns OBD info. Protocol, VIN, AdaptiveTiming value, requested PID counter, OBD application state, available vehicle PIDs, mil status, number of DTCs<br/><br/>
−
Returns OBD info. Protocol, VIN, AdaptiveTiming value, requested PID counter, OBD application state, available vehicle PIDs, mil status, number of DTCs
   
For example: Protocol:6,VIN:WVWZZZAUZFW125650,TM:0,CNT:11,ST:PROTOCOL DETECTION,P1:0x98180001,P2:0x1,P3:0xE0800020,P4:0x0,Fuel:OFF,MIL:0,DTC:0,ID0
 
For example: Protocol:6,VIN:WVWZZZAUZFW125650,TM:0,CNT:11,ST:PROTOCOL DETECTION,P1:0x98180001,P2:0x1,P3:0xE0800020,P4:0x0,Fuel:OFF,MIL:0,DTC:0,ID0
 +
<br/><br/>
 
According to obdinfo response you can check available OBD parameters via OBD Pid Reader. OBD reader can be found [https://www.glmsoftware.com/Downloads1.aspx here]
 
According to obdinfo response you can check available OBD parameters via OBD Pid Reader. OBD reader can be found [https://www.glmsoftware.com/Downloads1.aspx here]
−
 
+
[[Image:OBDII_SCAN.png|400px|left]]
 
   
 
   
 
Protocol:6 – specifies car supported protocol
 
Protocol:6 – specifies car supported protocol
Retrieved from "https://wiki.teltonika-gps.com/view/Special:MobileDiff/31615"