0
edits
Changes
Iridium Edge Configuration (view source)
Revision as of 15:30, 12 October 2022
, 15:30, 12 October 2022no edit summary
In order to enable Iridium support on FMB, first it is necessary to enable RS232 support and select “satellite backup” mode. Correct configuration is shown in the picture below.
In order to enable Iridium support on FMB, first it is necessary to enable RS232 support and select “satellite backup” mode. Correct configuration is shown in the picture below.
[[File:Iridium rs232 parameter config.png|center|500 px]]
[[File:Iridium rs232 parameter config.png|center|500x500 px]]
Next, there are a couple of configurable options. In the SBD config, IridiumEdge should be enabled and save/send period Set. This section can be found in the “Features” tab in the configurator.
Next, there are a couple of configurable options. In the SBD config, IridiumEdge should be enabled and save/send period Set. This section can be found in the “Features” tab in the configurator.