Line 3: |
Line 3: |
| This functionality was added in 03.28.04.Rev.00 firmware version. | | This functionality was added in 03.28.04.Rev.00 firmware version. |
| | | |
− | If this function is active, then all other settings associated with the this input are disabled.
| |
− |
| |
− | Frequency measurement can be performed in 2 different ways:
| |
− |
| |
− | # Frequency is measured by counting pulses over time period (997 ms). Method is used for frequencies higher than 100 Hz.
| |
− | # Frequency is measured by measuring time between pulses. Method is used for frequencies lower than 100 Hz.
| |
| When 2kHz pulse counter is enabled, all other scenarios '''will ignore''' corresponding DIN state, except DIN1 which can be used to wakeup device from Deep Sleep. | | When 2kHz pulse counter is enabled, all other scenarios '''will ignore''' corresponding DIN state, except DIN1 which can be used to wakeup device from Deep Sleep. |
| | | |
Line 280: |
Line 274: |
| | | |
| ''<small>1 – [1-2, 5-6, 21-22] - FMB110 DualSIM, FMB120, FMB122 DualSIM, FMB130, FMB140m FMB110 BLE, FMB120, FMB122 BLE</small>'' | | ''<small>1 – [1-2, 5-6, 21-22] - FMB110 DualSIM, FMB120, FMB122 DualSIM, FMB130, FMB140m FMB110 BLE, FMB120, FMB122 BLE</small>'' |
− | == Advanced pulse counter parameter in configurator == | + | == System parameters description== |
| + | |
| + | If this function is active, then all other settings associated with the this input are disabled. |
| + | |
| + | Frequency measurement can be performed in 2 different ways: |
| + | |
| + | # Frequency is measured by counting pulses over time period (997 ms). Method is used for frequencies higher than 100 Hz. |
| + | # Frequency is measured by measuring time between pulses. Method is used for frequencies lower than 100 Hz. |
| + | |
| + | ==Advanced pulse counter parameter in configurator== |
| | | |
| | | |
| [[File:Advanced pulse counter.png|frameless|1025x1025px]] | | [[File:Advanced pulse counter.png|frameless|1025x1025px]] |