Advanced Pulse Counter: Difference between revisions

Advanced Pulse Counter (view source)

35 bytes added , 2 October 2023

no edit summary

157

edits

@@ Line 3: / Line 3: @@
 This functionality was added in 03.28.04.Rev.00 firmware version.
-If this function is active, then all other settings associated with the this input are disabled.
-Frequency measurement can be performed in 2 different ways:
-# Frequency is measured by counting pulses over time period (997 ms). Method is used for frequencies higher than 100 Hz.
-# Frequency is measured by measuring time between pulses. Method is used for frequencies lower than 100 Hz.
 When 2kHz pulse counter is enabled, all other scenarios '''will ignore''' corresponding DIN state, except DIN1 which can be used to wakeup device from Deep Sleep.
@@ Line 280: / Line 274: @@
 ''<small>1 – [1-2, 5-6, 21-22] - FMB110 DualSIM, FMB120, FMB122 DualSIM, FMB130, FMB140m FMB110 BLE, FMB120, FMB122 BLE</small>''
-== Advanced pulse counter parameter in configurator ==
+== System parameters description==
+If this function is active, then all other settings associated with the this input are disabled.
+Frequency measurement can be performed in 2 different ways:
+# Frequency is measured by counting pulses over time period (997 ms). Method is used for frequencies higher than 100 Hz.
+# Frequency is measured by measuring time between pulses. Method is used for frequencies lower than 100 Hz.
+==Advanced pulse counter parameter in configurator==
 [[File:Advanced pulse counter.png|frameless|1025x1025px]]