0
edits
Changes
FMB640 and Tachograph Solution (view source)
Revision as of 15:28, 16 November 2018
, 15:28, 16 November 2018no edit summary
==INTRODUCTION==
==Introduction==
<br />
<br />
''*- requires company card reader software installation on a single company PC''
''*- requires company card reader software installation on a single company PC''
==SUPPORTED TACHOGRAPHS AND FORMATS==
==Supported tachographs and formats==
<br />
<br />
[[Image:Tacho_version_1.PNG|800px|center]]
[[Image:Tacho_version_1.PNG|800px|center]]
==CONNECTING TO TACHOGRAPH==
==Connecting to tachograph==
[[Image:Tacho_connection.PNG|800px|center]]
[[Image:Tacho_connection.PNG|800px|center]]
while tachograph is switched off:<br /></big>
while tachograph is switched off:<br /></big>
1. Turn off the vehicle ignition;<br />
2. Measure resistance between the C5 (CAN2 H) and C7 (CAN2 L) contacts;<br />
3. If the multimeter shows ~120 Ohms, skip the next step;<br />
4. If the multimeter shows kilo Ohms resistance then it is needed to connect tachograph C8 (CAN-RES) and C7 (CAN2 L) contacts with wire and then perform further actions;<br />
5. Re-measure the resistance of the line – it has to be ~120 Ohms.<br />
6. Connect CAN2 L and CAN2 H wires to tachograph (C5 (CAN2 H) and C7 (CAN2 L))<br />
• All of the same level CAN-L and CAN-H wires must be interlaced with each other.<br />
• All of the same level CAN-L and CAN-H wires must be interlaced with each other.<br />
==CHECKING CONNECTION (TACHOCHECK SMS)==
==Checking connection (Tachocheck SMS)==
<br />
<br />
'''Such SMS answer means DDD files can be downloaded from tachograph.'''
'''Such SMS answer means DDD files can be downloaded from tachograph.'''
'''
'''
==CONFIGURING DEVICE==
==Configuring device==
<br />
<br />
