Template:FMB2 First start card: Difference between revisions

(6 intermediate revisions by 3 users not shown)

Line 2:

{{{model|FMB20X}}} Small and professional waterproof tracker with high gain {{{GPS_antenna|internal}}} {{{antenna|GNSS/GSM antennas}}}, ~~Blue-tooth~~ and high capacity internal {{{battery|Ni-MH}}} battery{{{pic|[[Image:FMB202.png|400px|right]]}}}

{{{model|FMB20X}}} Small and professional waterproof tracker with high gain {{{GPS_antenna|internal}}} {{{antenna|GNSS/GSM antennas}}}, Bluetooth and high capacity internal {{{battery|Ni-MH}}} battery{{{pic|[[Image:FMB202.png|400px|right]]}}}

Line 12:

=='''How to insert Micro-SIM card'''==

# Unscrew the '''~~screws~~'''.

# '''Unscrew''' 6 screws counter-clockwise that are located on the '''bottom''' of the device.

# Remove the '''cover'''.

# Insert '''Micro-SIM''' card as shown with '''PIN request disabled''' or read '''{{{sim_pin|[[~~FMB202~~ Security info|Security info]]}}}''' how to enter it later in '''Configurator'''. Make sure that Micro-SIM card '''cut-off corner''' is pointing forward to slot.

# Insert '''Micro-SIM''' card as shown with '''PIN request disabled''' or read '''{{{sim_pin|[[FMB204 Security info|Security info]]}}}''' how to enter it later in '''Configurator'''. Make sure that Micro-SIM card '''cut-off corner''' is pointing forward to slot.

# Connect battery as shown to device~~. Position the battery in place where it does '''not obstruct other components'''~~.

# Connect battery as shown to device.

# ~~Attach~~ device '''cover''' and put the '''screws''' back in.

# After configuration, attach device '''cover''' and put the '''screws''' back in.

# Device is ready to be connected.

[[Image:case7.png|~~300px~~]][[Image:case4.png|~~300px~~]][[Image:case2.png|~~300px~~]]

[[Image:case7.png|250px]][[Image:case4.png|250px]][[Image:case2.png|250px]]

[[Image:case5.png|~~300px~~]][[Image:case3.png|~~300px~~]][[Image:case6.png|~~300px~~]]

[[Image:case5.png|250px]][[Image:case3.png|250px]][[Image:case6.png|250px]]