Template:FMB2 First start card: Difference between revisions

Latest revision as of 17:03, 15 January 2020

FMB20X Small and professional waterproof tracker with high gain internal GNSS/GSM antennas, Bluetooth and high capacity internal Ni-MH battery

How to insert Micro-SIM card

Unscrew 6 screws counter-clockwise that are located on the bottom of the device.
Remove the cover.
Insert Micro-SIM card as shown with PIN request disabled or read Security info how to enter it later in Configurator. Make sure that Micro-SIM card cut-off corner is pointing forward to slot.
Connect battery as shown to device.
After configuration, attach device cover and put the screws back in.
Device is ready to be connected.

Micro-SIM card insertion/removal must be performed when device is powered off – external voltage and battery are disconnected. Otherwise Micro-SIM card might be damaged or device will not detect it.

Cable colors


PIN NUMBER	PIN NAME	DESCRIPTION
Red	VCC (6-30)V DC (+)	Power supply (+6...30 V DC).
Black	GND (-)	Ground.
Yellow	DIN 1	Digital input, channel 1.
White/Green	DIN 2	Digital input, channel 2.
White	DIN 3	Digital input, channel 3.
Grey	AIN 1	Analog input, channel 1. Input range: 0-30 V DC.
White/Orange	DOUT 1	Digital output, channel 1. Open collector output. Max. 3,3 A DC.
Violet	DOUT 2	Digital output, channel 2. Open collector output. Max. 3,3 A DC.
Green	1WIRE DATA	Data channel for 1–Wire devices.
Blue	1WIRE POWER	+3,8 V output for 1–Wire devices.

@@ Line 2: / Line 2: @@
-<b>{{{model|FMB20X}}} Small and professional waterproof tracker with high gain {{{GPS_antenna|internal}}} {{{antenna|GNSS/GSM antennas}}}, Blue-tooth and high capacity internal {{{battery|Ni-MH}}} battery</b>{{{pic|[[Image:FMB202.png|400px|right]]}}}
+<b>{{{model|FMB20X}}} Small and professional waterproof tracker with high gain {{{GPS_antenna|internal}}} {{{antenna|GNSS/GSM antennas}}}, Bluetooth and high capacity internal {{{battery|Ni-MH}}} battery</b>{{{pic|[[Image:FMB202.png|400px|right]]}}}
@@ Line 19: / Line 19: @@
 # Device is ready to be connected.
-[[Image:case7.png|280px]][[Image:case4.png|280px]][[Image:case2.png|280px]] <br>
+[[Image:case7.png|250px]][[Image:case4.png|250px]][[Image:case2.png|250px]] <br>
-[[Image:case5.png|280px]][[Image:case3.png|280px]][[Image:case6.png|280px]]
+[[Image:case5.png|250px]][[Image:case3.png|250px]][[Image:case6.png|250px]]