Changes

1,538 bytes added ,  11:41, 7 October 2021
no edit summary
Line 181: Line 181:     
8.    Open the configurator and go to status window I/O info section. In Figure 7 you can see Ignition value is 1 and digital output 2 value is also 1, digital input 1 value should be 0 (if you connect relay to DOUT 1, then you will see the value in Digital output 1 section).
 
8.    Open the configurator and go to status window I/O info section. In Figure 7 you can see Ignition value is 1 and digital output 2 value is also 1, digital input 1 value should be 0 (if you connect relay to DOUT 1, then you will see the value in Digital output 1 section).
 +
[[File:IO info blur.png|500px|thumb|center]]
 +
<p style="text-align:center;">'''Figure 7'''. I/O info. Ignition
 +
 +
<p style="text-align:left;">In figure 7 you can see Ignition value is 1 and Digital output 2 value is also 1, digital input value should be 0 (if you connect relay to DOUT 1, then you will see the value in Digital output 1 section). <br>
 +
 +
9. Touch RFID card with the RFID Card reader, and after that in the configurator status window you should see that Digital output 2 changed it’s value to 0 ant digital input changed it’s value to 1. As shown in Figure 8. <br>
 +
 +
[[File:IO info. Digital Input.png|500px|thumb|center]]
 +
<p style="text-align:center;">'''Figure 8'''. I/O info. Digital Input
 +
 +
<p style="text-align:left;">10.  To check if your RFID card reader or iButton works you can go to I/O window and find iButton parameter as shown in Figure 9. <br>
 +
 +
[[File:IButton ID.png|500px|thumb|center]]
 +
<p style="text-align:center;">'''Figure 9'''. iButton ID
 +
 +
<p style="text-align:left;">When you touch the RFID card (or iButton) to RFID card (or iButton) reader these parameters should change to your iButton’s ID:
 +
[[File:IButton ID 2.png|500px|thumb|center]]
 +
<p style="text-align:center;">'''Figure 10'''. iButton ID<br>
 +
 +
<p style="text-align:left;">'''Operation example:'''<br>
 +
 +
When DOUT 2 value is 1, ignition is blocked and the vehicle will not be started. When the iButton/RFID card is attached to the reader, DOUT 2 value changes from 1 to 0 allowing you to start the transport normally.
 +
 +
 +
[[Category:Accessories]]

Navigation menu