Line 181: |
Line 181: |
| | | |
| 8. Open the configurator and go to status window I/O info section. In Figure 7 you can see Ignition value is 1 and digital output 2 value is also 1, digital input 1 value should be 0 (if you connect relay to DOUT 1, then you will see the value in Digital output 1 section). | | 8. Open the configurator and go to status window I/O info section. In Figure 7 you can see Ignition value is 1 and digital output 2 value is also 1, digital input 1 value should be 0 (if you connect relay to DOUT 1, then you will see the value in Digital output 1 section). |
| + | [[File:IO info blur.png|500px|thumb|center]] |
| + | <p style="text-align:center;">'''Figure 7'''. I/O info. Ignition |
| + | |
| + | <p style="text-align:left;">In figure 7 you can see Ignition value is 1 and Digital output 2 value is also 1, digital input value should be 0 (if you connect relay to DOUT 1, then you will see the value in Digital output 1 section). <br> |
| + | |
| + | 9. Touch RFID card with the RFID Card reader, and after that in the configurator status window you should see that Digital output 2 changed it’s value to 0 ant digital input changed it’s value to 1. As shown in Figure 8. <br> |
| + | |
| + | [[File:IO info. Digital Input.png|500px|thumb|center]] |
| + | <p style="text-align:center;">'''Figure 8'''. I/O info. Digital Input |
| + | |
| + | <p style="text-align:left;">10. To check if your RFID card reader or iButton works you can go to I/O window and find iButton parameter as shown in Figure 9. <br> |
| + | |
| + | [[File:IButton ID.png|500px|thumb|center]] |
| + | <p style="text-align:center;">'''Figure 9'''. iButton ID |
| + | |
| + | <p style="text-align:left;">When you touch the RFID card (or iButton) to RFID card (or iButton) reader these parameters should change to your iButton’s ID: |
| + | [[File:IButton ID 2.png|500px|thumb|center]] |
| + | <p style="text-align:center;">'''Figure 10'''. iButton ID<br> |
| + | |
| + | <p style="text-align:left;">'''Operation example:'''<br> |
| + | |
| + | When DOUT 2 value is 1, ignition is blocked and the vehicle will not be started. When the iButton/RFID card is attached to the reader, DOUT 2 value changes from 1 to 0 allowing you to start the transport normally. |
| + | |
| + | |
| + | [[Category:Accessories]] |