How to Install FMB640 on DAF XF: Difference between revisions

From Teltonika Telematics Wiki
(Blanked the page)
No edit summary
 
(5 intermediate revisions by 4 users not shown)
Line 1: Line 1:
[[File:800px-1_FMX640_+_DAF.png|800px|center]]


==Installation proccess==
* Below is shown main installation location:
[[File:2 Fuse panel cover.png|800px|center|Fuse panel cover]]
* Carefully unscrew the fuse panel screws and fold the panel down.
[[File:3 Fuse panel and screws location.png|800px|center|Fuse panel and screws location]]
* Where to find the main connector?
[[File:4 Main FMS connector location.png|800px|center|Main FMS connector location]]
* Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
[[File:5 FMB640 and DAF XF connection wires.png|800px|center|FMB640 and DAF XF connection]]
* After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if the installation is properly made. Turn on the ignition of the vehicle and send SMS command: “tachocheck”. If the response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
[[Category:FMB640 Manual| 9]]

Latest revision as of 16:27, 7 December 2021

Main Page > EOL Products > FMB640 > FMB640 Manual > How to Install FMB640 on DAF XF

Installation proccess

  • Below is shown main installation location:
Fuse panel cover
Fuse panel cover
  • Carefully unscrew the fuse panel screws and fold the panel down.
Fuse panel and screws location
Fuse panel and screws location
  • Where to find the main connector?
Main FMS connector location
Main FMS connector location
  • Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
FMB640 and DAF XF connection
FMB640 and DAF XF connection
  • After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if the installation is properly made. Turn on the ignition of the vehicle and send SMS command: “tachocheck”. If the response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.