Difference between revisions of "How to Install FMB641 on DAF XF"

From Wiki Knowledge Base | Teltonika GPS
m (Protected "How to Install FMB641 on DAF XF" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite)))
(Created page with "800px|center ==Installation proccess== * Below is shown main installation location: File:2 Fuse panel cover.png|800px|center|Fuse panel...")
(No difference)

Revision as of 15:55, 4 March 2022

Main Page > EOL Products > FMB641 > FMB641 Manual > How to Install FMB641 on DAF XF
800px-1 FMX640 + DAF.png

Installation proccess

  • Below is shown main installation location:
Fuse panel cover
  • Carefully unscrew the fuse panel screws and fold the panel down.
Fuse panel and screws location
  • Where to find the main connector?
Main FMS connector location
  • Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
FMB641 and DAF XF connection
  • After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if the installation is properly made. Turn on the ignition of the vehicle and send SMS command: “tachocheck”. If the response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
Retrieved from "https://wiki.teltonika-gps.com/index.php?title=How_to_Install_FMB641_on_DAF_XF&oldid=71591"