Line 113: |
Line 113: |
| | | |
| # Gently open ECAN02 cover using plastic pry tool from both sides | | # Gently open ECAN02 cover using plastic pry tool from both sides |
− | # Glue double-sided adhesive tape to casing inside as shown in figure 2 remove backing material | + | # Remove backing material on one side of double-sided adhesive tape |
− | # Insert CAN wires as shown in figure 3. Please make sure that correct slots are used (CAN High/CAN Low) | + | # Glue double-sided adhesive tape to casing |
| + | # Remove backing material on double-sided adhesive tape |
| + | # Insert CAN wires. Please make sure that correct slots are used (CAN High/CAN Low) |
| # Close the device. | | # Close the device. |
| # Device is ready-to-use. | | # Device is ready-to-use. |
| | | |
− | [[Image:{{{set_up_ECAN02_pic1|gently_open_ECAN02.png}}}|260px]][[Image:{{{set_up_ECAN02_pic2|insert_CAN_wires_to_ECAN02.png}}}|260px]][[Image:{{{set_up_ECAN02_pic3|close_ECAN02_cover.png}}}|260px]][[Image:{{{set_up_ECAN02_pic4|ECAN02_is_ready_to_use.png}}}|260px]] | + | [[File:ECAN02 (dvipusė įklijuojama) 01.png|frameless]] |
| + | [[File:ECAN02 (dvipusė įklijuojama) 02.png|frameless]] |
| + | [[File:ECAN02 (dvipusė įklijuojama) 03.png|frameless]] |
| + | [[File:ECAN02 (dvipusė įklijuojama) 04.png|frameless]] |
| + | [[File:ECAN02 (dvipusė įklijuojama) 05.png|frameless]] |
| + | [[File:ECAN02 (dvipusė įklijuojama) 06.png|frameless]] |
| + | [[File:ECAN02 (dvipusė įklijuojama) 07.png|frameless]] |
| | | |
| ==ECAN02 Certification & Approvals== | | ==ECAN02 Certification & Approvals== |