Line 45: |
Line 45: |
| '''CONNECTING WIRES''' | | '''CONNECTING WIRES''' |
| | | |
− | • Wires should be fastened to stable wires or other non-moving parts. Any heat emitting and/or moving objects should be kept away from the wires.<br />
| + | # Wires should be fastened to stable wires or other non-moving parts. Any heat emitting and/or moving objects should be kept away from the wires.<br /> |
− | • There should be no exposed wires. If factory isolation was removed while connecting wires, the isolation material should be applied.<br />
| + | # There should be no exposed wires. If factory isolation was removed while connecting wires, the isolation material should be applied.<br /> |
− | • If the wires are placed in the exterior or in places where they can be damaged or exposed to heat, humidity, dirt, etc., additional isolation should be <br />applied and the wires should not be loose.<br />
| + | # If the wires are placed in the exterior or in places where they can be damaged or exposed to heat, humidity, dirt, etc., additional isolation should be <br />applied and the wires should not be loose.<br /> |
− | • Wires cannot be connected to the board computers or control units.<br />
| + | # Wires cannot be connected to the board computers or control units.<br /> |
| | | |
| '''CONNECTING POWER SOURCE''' | | '''CONNECTING POWER SOURCE''' |
| | | |
− | • Be sure that after the car computer goes to sleep mode, power might be still available on the power wires. Depending on car, this may happen in 5 to 30 minutes period.<br />
| + | # Be sure that after the car computer goes to sleep mode, power might be still available on the power wires. Depending on car, this may happen in 5 to 30 minutes period.<br /> |
− | • When module is connected, measure voltage again to make sure it did not decrease.<br />
| + | # When module is connected, measure voltage again to make sure it did not decrease.<br /> |
− | • It is recommended to connect to the main power cable in the fuse box.<br />
| + | # It is recommended to connect to the main power cable in the fuse box.<br /> |
− | • 3 A, 125 V external fuse shall be used.<br />
| + | # 3 A, 125 V external fuse shall be used.<br /> |
| | | |
| '''CONNECTING GROUND WIRE''' | | '''CONNECTING GROUND WIRE''' |
| | | |
− | • Ground wire is connected to the vehicle frame or metal parts that are fixed to the frame.<br />
| + | # Ground wire is connected to the vehicle frame or metal parts that are fixed to the frame.<br /> |
− | • If the wire is fixed with the bolt, the loop must be connected to the end of the wire.<br />
| + | # If the wire is fixed with the bolt, the loop must be connected to the end of the wire.<br /> |
− | • For better contact scrub paint from the spot where loop is going to be connected..<br />
| + | # For better contact scrub paint from the spot where loop is going to be connected..<br /> |
| | | |
| [[Category:FTC921]] | | [[Category:FTC921]] |