Jump to content
  • EN

How to Install FMC640 on DAF XF: Difference between revisions

From Teltonika Telematics Wiki
Newer edit →
Created page with "800px|center ==Installation proccess== * Below is shown main installation location: 800px|center|Fuse panel cover..."
 
m Protected "How to Install FMC640 on DAF XF" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite))
(No difference)

Revision as of 12:54, 2 September 2019

Main Page > EOL Products > FMC640 > FMC640 Manual > How to Install FMC640 on DAF XF

Installation proccess

  • Below is shown main installation location:
Fuse panel cover
Fuse panel cover
  • Carefully unscrew the fuse panel screws and fold the panel down.
Fuse panel and screws location
Fuse panel and screws location
  • Where to find main connector?
Main FMS connector location
Main FMS connector location
  • Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
FMB640 and DAF XF connection
FMB640 and DAF XF connection
  • After installation and device configuration of FMC640 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
Retrieved from "https://wiki.teltonika-gps.com/index.php?title=How_to_Install_FMC640_on_DAF_XF&oldid=43868"