Jump to content
  • EN

How to Install FMB640 on DAF XF: Difference between revisions

From Teltonika Telematics Wiki
← Older editNewer edit →
VisualWikitext
No edit summary
mNo edit summary
Line 1: Line 1:
[[File:1 FMB + DAF.png|800px|center]]
[[File:800px-1_FMX640_+_DAF.png|800px|center]]


==Installation proccess==
==Installation proccess==

Revision as of 11:57, 2 December 2020

Main Page > EOL Products > FMB640 > FMB640 Manual > How to Install FMB640 on DAF XF

Installation proccess

  • Below is shown main installation location:
Fuse panel cover
Fuse panel cover
  • Carefully unscrew the fuse panel screws and fold the panel down.
Fuse panel and screws location
Fuse panel and screws location
  • Where to find the main connector?
Main FMS connector location
Main FMS connector location
  • Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
FMB640 and DAF XF connection
FMB640 and DAF XF connection
  • After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if the installation is properly made. Turn on the ignition of the vehicle and send SMS command: “tachocheck”. If the response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
Retrieved from "https://wiki.teltonika-gps.com/index.php?title=How_to_Install_FMB640_on_DAF_XF&oldid=61140"