Template:Magnetic Card Functionality

From Wiki Knowledge Base | Teltonika GPS

Magnetic card functionality

Figure 1 Magnetic card functionality parameters in configurator

Vehicle type

Magnetic card functionality parameter appearance is shown in Figure 1. The Other vehicle type ID is displayed only if Vehicle type is selected as Other This field allows configuring custom vehicle types see chapter Custom Vehicle Types.

Vehicle use type

On initial configuration, the parameters Vehicle type and Vehicle use type are set to None. This allows the vehicle to be started via immobilizer scenario with any license type (if immobilizer is enabled) enabled). If any other options are used for Vehicle type and Vehicle use type, Table 1 is used to lookup authorization with regards to driver's license type.

Buzzer Control

Different buzzers can be controlled when unauthorized cards are swiped see chapter Driver state logic for a specific or infinite amount of time:
• DOUT1 or DOUT2 are simply turned on for the amount of time configured
• Integrated uses built in buzzer in tracking device
• Reader uses built in buzzer in the magnetic card reader (if supports buzzer control command)

Authorization for immobilizer scenario

Based on parameters Vehicle type, Vehicle use type,Vehicle additional information, Table 1 data that is shown below and the license type obtained from the magnetic card via reader , the functionality decides whether or not the vehicle can be started (immobilizer scenario) The immobilizer must have priority to be set and output control configured in order for it to function.

Table 1 Authorization to start vehicle depending on license and vehicle type
Vehicle type B.1 B.2 B.3 B.4 T.1 T.2 T.3 T.4
Special Airconditioned Bus Private
Fix Route/Non-Fix Route
Airconditioned Bus Private
Fix Route/Non-Fix Route
Non Airconditioned Bus Private
Fix Route/Non-Fix Route
Double Deck Bus Private
Fix Route/Non-Fix Route
Special Public Bus Private
Fix Route/Non-Fix Route
Public Van Private
Fix Route/Non-Fix Route
Dump Truck Private
Fix Route/Non-Fix Route
Box Truck Private
Fix Route/Non-Fix Route
Liquid Truck Private
Fix Route/Non-Fix Route
Hazardous Truck Private
Fix Route/Non-Fix Route
Special Truck Private
Fix Route/Non-Fix Route
Container Truck Private
Fix Route/Non-Fix Route
Less than 20 passenger vehicle can be started
Vehicle weighing less than 3500 kg can be started
Vehicle can be started
Vehicle can‘t be started


If the Vehicle type is configured as Other, then the decision of whether the vehicle can be started or not is made by using the table located in Custom vehicle types tab.

Driver State Logic

Figure 2 Driver State Logic

The main driver registration, deregistration and swapping logic is shown in Figure 2.

Once deregistration event is generated, the start of the car is disallowed immediatelly (ignition off timer is not taken into consideration).