How to capture CAN adapter log from FMX1YX

Solution applies for these devices

FMB110 FMB120 FMB122 FMB125 FMB140 FMC125 FMC130 FMM125 FMM130 FMC125 FMU126 FMU130

Here are steps how to capture LV-CAN200, ALL-CAN300, CAN-CONTROL log from FMB1YX series devices.

This functionality is available after 03.08.00 firmware version.

1. Make sure that CAN adapter is connected properly to the vehicle and to the FMB1YX series device.
2. Start vehicle engine.
3. Send following SMS commands to FMX1YX device:
   • If you have set SMS login and password:login pass cpureset -> login pass log2sdfilterset 0;4;1
   • If SMS login and password are not set leave two spaces before command: aacpureset ->aalog2sdfilterset 0;4;1

     If command was sent correctly you should receive SMS Response:Enabled Trace Filters:3

     Make sure:

     Filter 0 - turn off all filters

     Filter 4 - turn on CAN adapter filter

     Filter 1 - save installed filters

4. After SMS response message CAN adapter log capturing has been started.
5. Wait at least 5 minutes to get enough CAN bus data and turn off vehicle engine.
6. Download captured log (dump) files.
   • Using Teltonika Configurator
     

     Please check Status info→Maintenance→Log/Dump and download dump YYYY_MM_DD_HH_MM_SS_FMB1YX_IMEI_Dump.zip.

   • Using FOTA WEB
     
     
     Enter FOTA WEB → Press on Devices tab → Select your device and press → Download from device → Continuous log files (2) (2 files. Each log size up to 1 MB)→. To start download process at once send following SMS command:
     • If you have set SMS login and password: login pass web_connect
     • If SMS login and password are not set leave two spaces before command: aaweb_connect

       If command was sent correctly you should receive SMS Response:web_connect resp:OK

       To find downloaded log press on device icon→Go to CONT.LOGS tab→Download IMEI_TIMESTAMP.zip

7. After you have downloaded log files send following SMS command to FMX1YX device:
   • If you have set SMS login and password: login pass log2sdfilterset 0
   • If SMS login and password are not set leave two spaces before command: aalog2sdfilterset 0

     If command was sent correctly you should receive SMS Response:Enabled Trace Filters:1

8. These log (dump) files can be read only with special software. Provide these files to your Teltonika Sales manager or Teltonika Support team for further investigation.