How to Install FMB640 on DAF XF
From Wiki Knowledge Base | Teltonika GPS
Revision as of 07:31, 22 August 2019 by Aurimas.vanagas (talk | contribs)
Main Page > EOL Products > FMB640 > FMB640 Manual > How to Install FMB640 on DAF XF
Installation proccess
- Below is shown main installation location:
- Carefully unscrew the fuse panel screws and fold the panel down.
- Where to find main connector?
- Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
- After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
