Template:FMP1 First start card

From Wiki Knowledge Base | Teltonika GPS
Revision as of 14:11, 2 April 2020 by Gabrielius.jankauskas (talk | contribs) (Created page with "centre <b>{{{description|Plug and Play tracker with GNSS, GSM and Bluetooth connectivity and cigarette lighter power connector for easy in...")

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)
Qsg rut950 teltonika.PNG


Plug and Play tracker with GNSS, GSM and Bluetooth connectivity and cigarette lighter power connector for easy installation.

FMP100 demo.png




Know your device

FMP100-withoutcover.png


Set up your device

How to insert Micro-SIM card and connect the battery

  1. Insert the SIM tray removal tool into the hole on the SIM card

tray and then push until the tray pops out.

  1. Split device cover to access battery connector inside.
  2. Connect the battery as shown to device.
  3. Gently close device cover back.
  4. Insert Nano-SIM card as shown with PIN request disabled or

read our Wiki how to enter it later in Teltonika Configurator. Make sure that Nano-SIM card is fitted properly into the tray.

  1. Insert the SIM card tray back.
  2. After configuration, see “PC Connection (Windows)”.

Device is ready to be mounted.
FMP100-insertsim1.png     FMP100-insertsim2.png     FMP100-insertsim3.png     FMP100-insertsim4.png     FMP100-insertsim5.png     FMP100-insertsim6.png

Alert.png
Nano-SIM card insertion/removal must be performed when device is powered off – external voltage and battery are disconnected. Otherwise Nano-SIM card might be damaged or device will not detect it.
Retrieved from "https://wiki.teltonika-gps.com/index.php?title=Template:FMP1_First_start_card&oldid=56159"