Inateck BCST-70 Configuration

Configure FM device using Teltonika configurator

1. In System settings, enable Codec8 Extended
   
   
   
   
2. In GPRS settings, configure GPRS Settings and Server Settings.
   
   
3. In Bluetooth settings,

• Enable Bluetooth, set this setting as either "Enable (hidden)" or "Enable (visible)", otherwise Bluetooth will be disabled
• Under Bluetooth Control, click Discover so it would detect devices within vicinity.
  
  
  
  
• Once devices are discovered, select BCST-70-XXXX-SPP then proceed to tick Pair
• After successful pairing, scanner should show under Paired Devices.
  
  
  
  

NOTE: : If in case the Scanner is not discovered, do the following steps on Bluetooth Pairing.

Enable Bluetooth Pairing

1. Scan “Enter Setup”
   
   
   
   
2. Scan “ Bluetooth Pairing”
   
   
   
   
3. Scan the "Exit with Save" barcode
   
   
   
   

Scanner Auto Connect Configuration

• Fill up the “Auto Connect To External Device“ with as follows:
  
  
  
  

• Select Connection Mode as, Inateck Scanner.
• Enter the External MAC, can be seen on Paired Devices at the upper left corner.
• Enter the External Name, can be seen on Paired Devices at the lower right corner.
• Enter the External Pin, if the scanner has pin code set otherwise leave as blank.
  

• Fill up the “Authorized Devices MAC List“ same with the External MAC.
  
  

NOTE: : It is important to fill out the auto connect so you won‘t need to Pair the device again on the Configurator.

• To receive the data to server enable corresponding BT Status IO element to Low.
  
  

NOTE: : If Scanner is connected BT Status value would be read as 2