Inateck BCST-70 Configuration
Revision as of 10:33, 2 May 2023 by Patrick.sangalang (talk | contribs) (Protected "Inateck BCST-70 Configuration" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite)))
Main Page > Accessories > Inateck BCST-70 Barcode Scanner > Inateck BCST-70 Configuration
Configure FM device using Teltonika configurator
- In System settings, enable Codec8 Extended
- In GPRS settings, configure GPRS Settings and Server Settings.
- In Bluetooth settings,
- Enable Bluetooth, set this setting as either "Enable (hidden)" or "Enable (visible)", otherwise Bluetooth will be disabled
- Under Bluetooth Control, click Discover so it would detect devices within vicinity.
- Once devices are discovered, select BCST-70-XXXX-SPP then proceed to tick Pair
- After successful pairing, scanner should show under Paired Devices.
NOTE: : If in case the Scanner is not discovered, do the following steps on Bluetooth Pairing.
Enable Bluetooth Pairing
- Scan “Enter Setup”
- Scan “ Bluetooth Pairing”
- Scan the "Exit with Save" barcode
Scanner Auto Connect Configuration
- Fill up the “Auto Connect To External Device“ with as follows:
- Select Connection Mode as, Inateck Scanner.
- Enter the External MAC, can be seen on Paired Devices at the upper left corner.
- Enter the External Name, can be seen on Paired Devices at the lower right corner.
- Enter the External Pin, if the scanner has pin code set otherwise leave as blank.
- Fill up the “Authorized Devices MAC List“ same with the External MAC.
NOTE: : It is important to fill out the auto connect so you won‘t need to Pair the device again on the Configurator.
- To receive the data to server enable corresponding BT Status IO element to Low.
NOTE: : If Scanner is connected BT Status value would be read as 2