EYE FUNCTIONALITIES NEW
Revision as of 16:50, 12 May 2023 by Aurimas.Alesius (talk | contribs)
Page Description
This page will describe EYE device functionalities, their flow and functionality supporting software versions.
Functionalities
Connecting to the device
Flow for firmware versions from 1.2.1.R.0 to 1.2.8.R.2
SW version requirements | EYE APP: 1.2.0-60+
Firmware: 1.2.1.R.0 to 1.2.8.R.2 | ||||
---|---|---|---|---|---|
Step No. | 1 | 2 | 3 | ||
Short step desc. | Tap the selected device to connect to it | Wait for connection | Enter Pin | Successfully connected | |
Successful attempt at functionality visual | |||||
Short step desc. | Tap the selected device to connect to it | Wait for device to connect | Enter PIN | You have connected to the device | |
Additional desc. | Device is locked for 5 min but will allow to connect with PIN again after timeout | Device is locked for 5 min but will allow to connect with PIN again after timeout, thus this is continued in infinite loop. | |||
Failed attempt at functionality visual |
PUK code unlock
SW version requirements | EYE APP: 1.2.0-60+
Firmware: 1.2.9.R.8+ | ||||
---|---|---|---|---|---|
Step No. | |||||
Short step desc. | Tap the blocked device to connect to it | Enter PUK | Connected | ||
Additional desc. | PIN automatically resets to default | ||||
Successful attempt at functionality visual | |||||
Step desc. | Tap the selected device to connect to it | Enter PUK incorrectly | Fail to enter PIN correctly 4 more times | ||
Additional desc. | PUK is rejected and you can only go back or enter correct PUK | ||||
Failed attempt at functionality visual |
Hibernate mode
Send to sleep
SW version requirements | EYE APP: 1.2.0-60+
Firmware: 1.2.9.R.8+ | ||
---|---|---|---|
Step No. | 1 | 2 | 3 |
Short step desc. | While connected and in overview tap "Send device to sleep" | Confirm your selection | Wait for EYE App to disconnect |
Additional desc. | Device is no longer connectable or findable until wake up step is performed. | ||
Successful attempt at functionality visual |
Wake up
SW version requirements | Firmware: 1.2.9.R.8+ | ||||
---|---|---|---|---|---|
Step No. | 1-3 | 4 | |||
Short step desc. | Attach magnet to sleeping device and wait for LED to blink. | Device starts broacasting | |||
Additional desc. | Now device is discoverabled, scannable, connectable via BLE. | ||||
Successful attempt at functionality visual |