Changes

'''(!) Required FW version''' - 03.00.14.Rev.111

'''(!) Required FW version''' - 03.00.14.Rev.111

*Make sure Data Protocol is set to Codec 8 Extended

*Make sure '''Data Protocol''' is set to [[Codec#Codec_8_Extended | Codec 8 Extended]]

[[Image:Data_protocol.gif|300px]]

[[Image:Data_protocol.gif|300px]]

*In RS232 \ RS485 settings tab, make sure to choose DualCam to COM1/COM2 settings, and set the required baudrate.  

*In ''RS232 \ RS485 settings tab'', make sure to choose '''DualCam''' to '''COM1/COM2 settings''', and set the required '''baudrate'''.

[[Image:Dualcam rs232.png|600px]]

[[Image:Dualcam rs232.png|600px]]

'''

'''

*As soon as DualCam is selected, COM1 Camera and Camera I/O settings tabs will appear in the configurator menu.  

*As soon as '''DualCam''' is selected, ''COM1 Camera'' and ''Camera I/O settings'' tabs will appear in the configurator menu.

[[Image:Com1 cameraio.png|600px]]

[[Image:Com1 cameraio.png|600px]]

*In appeared COM1 Camera tab, make sure to configure everything by your needs, and do not forget to complete the "Domain" and "Port" settings in "DualCam" Scenario Settings

*In appeared ''COM1 Camera tab'', make sure to '''configure everything by your needs''', and do not forget to complete the '''"Domain"''' and '''"Port"''' settings in ''"DualCam" Scenario Settings''

*'''''NOTE:''''' ''This is a base setup for the device to work properly. Other device configuration is made according to your needs.   

*'''''NOTE:''''' ''This is a base setup for the device to work properly. Other device configuration is made according to your needs.