FMM640 Auto Geofence settings
From Wiki Knowledge Base | Teltonika GPS
Revision as of 15:00, 22 August 2019 by 212.59.13.226 (talk) (Created page with "{{Template:FMM640 Auto Geofence settings|model=FMM640|pic_autogeofence=300px|right}} Category:FMB640 Configuration")
Main Page > EOL Products > FMM640 > FMM640 Configuration > FMM640 Auto Geofence settings
AutoGeofence – the last known position after movement = off. If your car is being taken away – you can be notified. The shape and size of the geofence zones are configurable. There is a possibility to state whether entering in or out of the geofence triggers an asynchronous message. Auto Geofencing option can be configured by following parameters:
- Priority – Priority of generated event, which will be applied to saved record.
- Eventual Records - Scenario status will be (or not, if disabled) sent with each AVL
record. Generate Event:
- On Entrace – Event generation on Geofence entrance.
- On Exit – Event generation on Geofence exit.
- On Both - Event generation on Geofence entrance or exit.
- Activation Timeout – Time period before Geofence is activated after vehicle stops.
- Radius - Radius of circle where in center of it is last coordinates of device when vehicle
engine was running. Deactivate By:
- Ignition – if ignition becomes high it will drop AutoGeofenze Zone
- iButton – if iButton is attached it will drop AutoGeofence Zone
- Engine RPM - if engine RPM becomes more than zero it will drop AutoGeofence zone
