| Line 144: |
Line 144: |
| | * {{{text_dout|DOUT1/DOUT2}}} will always be ON if, for example, DOUT deactivation is set to DIN1, but DIN1 will be never turned ON, or when duration timeout is set to maximum value (2147483647) which is about 68 years. | | * {{{text_dout|DOUT1/DOUT2}}} will always be ON if, for example, DOUT deactivation is set to DIN1, but DIN1 will be never turned ON, or when duration timeout is set to maximum value (2147483647) which is about 68 years. |
| | }}} | | }}} |
| − |
| |
| − | {{{immobilizer_feature|==Immobilizer==
| |
| − |
| |
| − | [[Image:Immobilizer.gif|{{{general|size}}}|right]]
| |
| − |
| |
| − | If ''DOUT Control'' is disabled, the scenario will only generate events without digital output activation. If ''DOUT Control'' is enabled {{{text_dout|DOUT1/DOUT2}}} turns ON if ignition turns ON (''Ignition Source'' is configured to 1). After any iButton ID is attached, {{{text_dout|DOUT1/DOUT2}}} turns OFF. After iButton identification configured ''Ignition Source'' can be turned OFF (''Ignition Source'' is configured to 0) for no longer than 30 seconds, otherwise, immobilizer must be repeated. If ''iButton List Check'' parameter is enabled, the authorization will be successful only if the attached iButton is specified in iButton list.<br/>
| |
| − | <br/><br/>
| |
| − | Ignition off timeout parameter is used to set the duration after which authorization is activated, when the ignition is turned off. For example, if Ignition off timeout is set to 30 seconds, when the driver turns the ignition off, he has 30 seconds until the immobilizer security check turns on again. In other words, if the driver turns off the ignition and turns it back on in less than 30 seconds, then he will not have to attach the iButton to the reader again.
| |
| − |
| |
| − |
| |
| − | From the firmware version '''[https://wiki.teltonika-gps.com/view/{{{model|MSP500}}}_firmware_errata 03.25.14]''' iBeacon authentication was introduced. iBeacon authentication works in the same way as iButton authentication. To use authorized iBeacons, the iBeacon list should be filled in the device configurator. Instructions how to list iBeacons in MSP500 devices can be found '''[https://wiki.teltonika-gps.com/view/{{{model|MSP500}}}_Beacon_List here]'''.
| |
| − |
| |
| − | By using iBeacon authorization, immobilizer feature can be used with devices which doesn't have 1-wire data connection available.
| |
| − | <br/><br/><youtube>gjuiJjAejWU</youtube>}}}
| |
| − |
| |
| − | {{{ibutton_feature|==iButton Read Notification==
| |
| − |
| |
| − | This functionality allows user to see when iButton is read. {{{text_dout|DOUT1/DOUT2}}} turns on for a configured duration and after DOUT ON duration ends {{{text_dout|DOUT1/DOUT2}}} does not turn on even if iButton is left attached.
| |
| − | [[Image:IButton_Read_Notification.gif|{{{general|size}}}|left]]<br/><br/><br/><br/><br/><br/><br/><br/><br/><br/><br/>}}}
| |
| | | | |
| | ==GNSS Fuel Counter== | | ==GNSS Fuel Counter== |