139
edits
Changes
mLine 11:
Line 11: − + − + − * Reader scans for RFID card or button press all time after it is paired+ − + − + − * Depending on the configuration, read card ID can be present on the advertising packet or/and on characteristic+ − + − * Reader can be on/off by long button press+ − + − − − − |Operating frequency − |13,56MHz − |- − |Supported standards − |MIFARE® Classic − MIFARE® DESFire − |- − |Interface − |Bluetooth Line 48:
Line 36: + + + Line 53:
Line 44: − + + + − First, you have to make sure that NBL-2 firmware version is updated to 1.3. Go to NBL Tools application -> Device -> Characteristic -> Device Information Service -> Firmware Revision String.+
no edit summary
'''Functionality:'''
'''Futures:'''
* Unpaired reader (state after default reset) is waiting for button only
* Mifare® Classic, Desfire card supports
* Bluetooth low energy module
* In the case previously mentioned events occur, the reader sends an advertising packet for Ta time in period Tb. Defaults: Ta=50sec, Tb=100ms
* Operating frequency - 13,56MHz
* While NBL-2 is advertising the green led is flashing slowly. The reader stops blinking and advertising after disconnection.
* Built in two LED indicators
* Built in two buttons
* Reader closes the connection and goes into low power 50 seconds after the last data exchange.
* UID and card DATA available
* Configure via BL link
* Reader performs sensor measurement in a period that is configurable
* Firmware update via Bluetooth
* Button reacts immediately
* Sensors configuration is set by GATT services.
* Detecting the start and stop of the vehicle. This mode is active immediately after turning on the device.<br />
==Product Specification==
==Product Specification==
{| class="wikitable"
{| class="wikitable"
|-
|-
|Supply voltage
|Supply voltage
|Size (mm)
|Size (mm)
|58 x 99 x 19
|58 x 99 x 19
|-
|Weight
|43.78 g
|-
|-
|Type
|Type
|}
|}
==NBL-2 configuration==
==NBL-2 updating==
First, you have to make sure that NBL-2 firmware version is updated to 1.3.
If the firmware version is lower than 1.3, it is necessary to update the device.
'''1. Updating NBL-2'''
'''1. Updating NBL-2'''
Go to NBL Tools application -> Device -> Characteristic -> Device Information Service -> Firmware Revision String.
[[File:NBL_conf1.jpg.jpg|alt=|frameless|520x520px]] [[File:NBL_conf2.jpg.jpg|alt=|border|frameless|520x520px]] [[File:NBL_conf3.jpg.jpg|alt=|frameless|519x519px]]
[[File:NBL_conf1.jpg.jpg|alt=|frameless|520x520px]] [[File:NBL_conf2.jpg.jpg|alt=|border|frameless|520x520px]] [[File:NBL_conf3.jpg.jpg|alt=|frameless|519x519px]]