Changes

no edit summary
Line 1: Line 1: −
Wiki.
+
== Struggle after upgrading CAN-CONTROL to CAN-CONTROL+Immobilizer? ==
FAQ
+
Possible encounters after upgrading CAN bus adapter:
   −
Upgrading CAN-CONTROL to CAN-CONTROl+Immobilizer
+
* Vehicle doors Lock/Unlock is not working;
<br>
+
* Vehicle doors Lock/Unlock is working but engine Blocking/Unblocking does not and after sending commands, the response is: "''CAN-CONTROL cmd not supported''".
Possible problems:
  −
<br>
  −
1. Doors Lock/Unlock is not working.<br>
  −
2. Doors Lock/Unlock works but engine blocking and unblock does not. Most of times response will be: CMD not supported. In some situations engine block will work but unblocking will not.<br>
  −
<br>
  −
After installation is done and program number is set please do learning procedure.
  −
<br>
  −
1. send lvcansetprog 11120 (Or any other) <br>
  −
2. send lvcansetprog (one that is for your car model)<br>
  −
3. After you will receive response please do learning with key locking/unlocking 3 times. lock>unlock;lock>unlock;lock>unlock;
  −
<br>
  −
Now you can try commands to open and close doors.<br>
  −
Now you can try commands to block and unblock engine.<br>
  −
<br>
  −
All sms/gprs responces should inform you that command has been completed succesffully.<br>
     −
Note: If installing CAN-CONTROL adapter into different vehicle learning must be initiated. If adapter will be installed back on previous car model learning step must be repeated.<br>
+
If You endure with any of these issues - we offer a perfect solution.
 +
 
 +
== Solution ==
 +
After installation is complete and CAN bus adapter program is set, please, follow these steps:
 +
 
 +
# Do a learning procedure - using the vehicle key, unlock and lock vehicle '''three''' '''times''';
 +
# Send GPRS command - "  lvcansetprog 11120" (or any other). Program number must contain 5 digits.
 +
# Send GPRS command - "  lvcansetprog ''the one that is for Your vehicle model''". Program number can be seen in at the top of the CAN adapter connection scheme.
 +
# After receiving a response to a command, repeat the learning procedure (first step).
 +
 
 +
'''Note''': Before SMS text, two space symbols should be inserted if no SMS username or password was set in [[FMB001 SMS/Call settings|SMS / Call settings]].
 +
 
 +
After completed these steps, commands to open/close and to block/unblock engine can be performed.
 +
 
 +
All SMS/GPRS responses should inform You that particular command has been completed successfully.
 +
 
 +
'''Note''': if installing CAN-CONTROL adapter into different vehicle learning must be initiated ("first solution step"). If adapter will be installed again on the previous vehicle - learning step must be repeated.
Anonymous user