Changes
Upgrading CAN-CONTROL to CAN-CONTROl+Immobilizer (view source)
Revision as of 16:18, 21 January 2021
, 16:18, 21 January 2021no edit summary
== Struggle after upgrading CAN-CONTROL to CAN-CONTROL+Immobilizer? ==
Possible encounters after upgrading CAN bus adapter:
* Vehicle doors Lock/Unlock is not working;
* Vehicle doors Lock/Unlock is working but engine Blocking/Unblocking does not and after sending commands, the response is: "''CAN-CONTROL cmd not supported''".
Note: If installing CAN-CONTROL adapter into different vehicle learning must be initiated. If adapter will be installed back on previous car model learning step must be repeated.<br>
If You endure with any of these issues - we offer a perfect solution.
== Solution ==
After installation is complete and CAN bus adapter program is set, please, follow these steps:
# Do a learning procedure - using the vehicle key, unlock and lock vehicle '''three''' '''times''';
# Send GPRS command - " lvcansetprog 11120" (or any other). Program number must contain 5 digits.
# Send GPRS command - " lvcansetprog ''the one that is for Your vehicle model''". Program number can be seen in at the top of the CAN adapter connection scheme.
# After receiving a response to a command, repeat the learning procedure (first step).
'''Note''': Before SMS text, two space symbols should be inserted if no SMS username or password was set in [[FMB001 SMS/Call settings|SMS / Call settings]].
After completed these steps, commands to open/close and to block/unblock engine can be performed.
All SMS/GPRS responses should inform You that particular command has been completed successfully.
'''Note''': if installing CAN-CONTROL adapter into different vehicle learning must be initiated ("first solution step"). If adapter will be installed again on the previous vehicle - learning step must be repeated.
