FM6300 External Devices
From Wiki Knowledge Base | Teltonika GPS
Main Page > EOL Products > FM6300 > FM6300 Configuration > FM6300 External Devices
External Devices do not depend on selected profile; they are common for all profiles. To configure these parameters choose the TAB named “External Devices” and make all necessary changes.
|Are used to configure CAN line and Tachograph setting such as Enable/Disable, baudrate, operation mode, tachograph ignition source, tachograph type.
|User can enable Web DDD synchronization functionality; enter tacho web server domain and port.User can enable Web DDD synchronization functionality; enter tacho web server domain and port.
|Tacho Web start delay
|When ignition is on Tacho web starts after this delay.
|Analog Input Settings
|User can change the range of analog inputs. There are two possible changes: 10 V (0-10 V) and 30 V (0-30 V).
|COM1 and COM2 Settings
|Configures COM1 and COM2 ports. User can configure baudrate, working mode, enable/disable timestamp and change CMD ID(used to identify from which COM port data came)
|COM start/end byte
|COM1 and COM2 start and end byte are filter for TCP Binary link mode.
|Configures RS485 settings such as activation of RS485 protocol, baudrate and working mode.
|LLS Sensor Settings
|Allows user to set LLS sensors addresses in preffered order