FMA202 GSM settings, operator list

From Wiki Knowledge Base | Teltonika GPS
Main Page > End of Life Products > FMA202 > FMA202 Configuration > FMA202 GSM settings, operator list

Operator list

Operators list – FMA202 can work in different modes (use different settings) according to the operator list defined. Operator list is used for Data Acquisition Mode switching (Data Acquisition Mode settings for more details). Modes are changed based on GSM operator FMA202 is connected to.

FM36YX Operator list configuration.png

If operator list is left empty, it will allow using GPRS to any GSM operator. Please note that FMA202 will work in Unknown mode only (make sure it is configured to allow data sending – GPRS context is enabled).

Operator Black List

Operator BlackList Functionality algorithm: Device tries to connect to an operator with the strongest signal. It will prioritize operators which are specified in the operator list. If no operators from the operator list are available, the device will try to connect to an operator from the blacklist. If the device connects to an operator from the blacklist, it will not be allowed to connect to the internet or send SMS messages. If no suitable operator is found on both lists, the device will try to connect to a remaining available operator with the strongest signal. The brief functionality is shown in diagram below:


FMA1 Operator Black list functionality.png

FM36YX Operator Black list configuration.png