FMA204 Installation instruction

From Wiki Knowledge Base | Teltonika GPS
Main Page > Fleet management > Old products > FMA204 > FMA204 Manual > FMA204 Installation instruction

Possible mounting zones

Trucks[edit | edit source]

It is strongly recommended to mount FMA204 outside of the vehicle with the sticker direction to the sky.
Trucks FMA.png


Most commercial trucks have plastic hood in front of the vehicle. It is recommended to mount FMA204 under the hood. Power cord output of the device should be at the bottom. If it is not possible, if a front hood is made of some kind of metal, the device can be mounted inside the car on the front panel as close as possible to the front window.
Truck Inside.png


Tractors[edit | edit source]

It is strongly recommended to mount FMA204 outside of the vehicle with the sticker direction to the sky.
Tractors FMA.png

Motor bikes[edit | edit source]

FMA204 device should be mounted on outside.
Possible mounting places for motorbikes FMA.png


FMA204 cannot be mounted under the seat!
Not mount device under seat FMA.png

Light vehicles[edit | edit source]

Most light vehicles has oblique front window that opens most part of interior front panel. FMA204 can be mounted under the plastic panel behind the front window, with the sticker direction to a window (sky).
Light Vehicles.png

Recommended mounting positions[edit | edit source]

Best FMA204 mounting position is outside of vehicle with any metal above the device. Recommended deviation from horizontal axis of vehicle max 3-5°.
Mounting positions.png


Mounting position and recommended deviation from longitudinal axis of vehicle ±2°.
Mounting positions v2.png

Restrictions[edit | edit source]

FMA204 device can not be mounted inside in the vehicle door!
Inside door FMA.png


FMA204 device cannot be mounted inside the vehicle!
Inside vehicles FMA.png

Connecting power wires[edit | edit source]

  1. Device should be connected directly to battery. Power supply: 6V/12V/24V.
  2. If FMA204 is used in 6V system and power cables are extended.

Extension cable resistance should be less than 60 mΩ in sum of both, positive and negative, wires. 30 mΩ for single wire.
FMB2YXLi connection to the car circuit FMA.png