FMB640 ContiPressureCheck

From Wiki Knowledge Base | Teltonika GPS
Main Page > Professional Trackers > FMB640 > FMB640 Configuration > FMB640 ContiPressureCheck


FMB640 device is able to read data from the Continental “ContiPressureCheck” tire pressure monitoring system. This solution provides you with live data about the state of the tires in your fleet, therefore helping you to make decisions that will lead to better fuel economy, reduced tire-related breakdowns, and extended tire lifespan.
The pressure sensors are mounted inside the Continental tire ensuring accurate information that is sent to the Central Control Unit. FMB640 connects to this unit via the CAN line and can read data about the total number of tires controlled, the total number of axles, graphical position, and information regarding about every tire pressure, temperature and faults.

TMPS iliustracija V1.0.png

Different fleets have different information priorities. “ContiPressureCheck” data is saved as a separate record. You are able to set how often the device saves this information by configuring the data reading period. This ensures that you will save data traffic costs and get the information that you need as often as you need it.

The data is gathered from CAN interface: a total number of tires controlled, the total number of axles, graphical position, and information regarding every tire. TPMS period affects only record saving.

FMB640 ContiPressureCheck.png


To get data from TPMS sensors, in System settings choose Codec 8 Extended as Data protocol.

TPMS Data protocol.png

To get current TPMS IO elements, they should be enabled in ContiPressureCheck. Also, after that, you will need to set Data saving period which means how often the device should save values from sensors

TPMS IO settings.png

Continental TPMS data is read from the FMS CAN bus lines. Please choose one option (CAN1 or CAN2) which will be used in ContiPressureCheck.

Continental Tire Pressure Check CAN source.png

If you have FMB640 CAN1 bus lines connected to FMS, in CAN / Tachograph settings CAN1 bus mode must be set to NORMAL and Baud rate - 250kbps. If you have FMB640 CAN2 bus lines connected to FMS, the CAN2 Baud rate must be set to 250kbps.

CAN bus settings.png

External Links