Changes

System settings have 7 configurable parameters:

System settings have 5 configurable parameters:

*Sleep settings, where user can turn GPS sleep/deep sleep on or off;

*Sleep mode - where user can turn GPS sleep/deep sleep on or off;

*Analog Input Settings, where user can choose analog input range 10 V or 30 V, depending on needed accuracy (lower range gives higher accuracy of measurements), and input voltage;

*Sleep timeout - timer which starts after every sleep condition is met and will end up with device going to sleep mode;

*Object Motion Detection Settings, where user can configure 3 ways how {{{model|FMB630}}} will detect stopped movement, and change its working mode;

*GNSS Settings, where user can choose satellite system and GNSS FIX Timeout Time (if after timeout there will not be synchronized time, it will be synchronized via NTP server);

*Ignition Source sets ignition triggered functionalities to be triggered by:

*Ignition Source sets ignition triggered functionalities to be triggered by:

**Power Voltage (if voltage is between High Voltage Level and Low Voltage Level the ignition is considered to be turned on);

**Power Voltage (if voltage is between High Voltage Level and Low Voltage Level the ignition is considered to be turned on);

**Digital Input (DIN1 ON – ignition on, DIN1 OFF – ignition off);

**Digital Input 1;

**Digital Input 4;

**Movement (if accelerometer/movement sensor detects movement then ignition is on, if movement stops – ignition is off).

**Movement (if accelerometer/movement sensor detects movement then ignition is on, if movement stops – ignition is off).