Changes

Template:FMA CAN adapters (view source)

Revision as of 06:45, 22 August 2018

1,429 bytes removed ,  06:45, 22 August 2018
→‎LV-CAN200 and ALL-CAN300 program number configuration via configurator
Line 29: Line 29:  
----
 
----
 
LV-CAN200 and ALL-CAN300 program number can be set remotely, using SMS command, where X is new program number value (more CAN commands can be found in section {{{ctrSMS|[[Template:FMB_SMS/GPRS_command_list#Commands_related_to_LV-CAN200.2FALL-CAN300]]}}}):<br/>''"lvcansetprog X"''<br/>
 
LV-CAN200 and ALL-CAN300 program number can be set remotely, using SMS command, where X is new program number value (more CAN commands can be found in section {{{ctrSMS|[[Template:FMB_SMS/GPRS_command_list#Commands_related_to_LV-CAN200.2FALL-CAN300]]}}}):<br/>''"lvcansetprog X"''<br/>
−
  −
===LV-CAN200 and ALL-CAN300 program number configuration via configurator===
  −
----
  −
{{{model|FMB1YX}}} shares the same USB port for connecting LV-CAN200 or ALL-CAN300 adapter and configuring device with PC.
  −
{{{model|FMB1YX}}} can be configured using “SCAN” function or “Offline Configuration”
  −
SCAN function – is in use when {{{model|FMB1YX}}} is connected to CAN adapter, then wait 10s (Note, that car engine must be started), disconnect adapter from {{{model|FMB1YX}}} , and connect PC USB cable to {{{model|FMB1YX}}} Device. It is very important not to disconnect {{{model|FMB1YX}}} from power source during this operation, because if {{{model|FMB1YX}}} is reconnected all received CAN bus data will be lost. {{{model|FMB1YX}}} remembers received data from LV-CAN200 or ALL-CAN300 and at the end of the procedure when “SCAN” button is pressed, user will see all CAN data which is sent by adapter. Enable CAN data which needs send to server and save configuration pressing “Save” button.<br/>
  −
To configure CAN data:<br/>
  −
1. In car, connect LV-CAN200 or ALL-CAN300 to CAN bus and to the {{{model|FMB1YX}}} device , wait 10 seconds. Note, that car engine must be started.<br/>
  −
2. Disconnect LV-CAN200 or ALL-CAN300 from {{{model|FMB1YX}}} , and connect PC USB cable to {{{model|FMB1YX}}} Device. It is very important not to disconnect {{{model|FMB1YX}}} from power source, because then all CAN data will be lost.
      
===Selecting LV-CAN200 and ALL-CAN300 program number manually===
 
===Selecting LV-CAN200 and ALL-CAN300 program number manually===
Retrieved from "https://wiki.teltonika-gps.com/view/Special:MobileDiff/17489"

Navigation menu