494
edits
Changes
Template:FMA2 System Settings (view source)
Revision as of 09:23, 6 September 2018
, 09:23, 6 September 2018no edit summary
{{{foto|[[Image:FMA2_Configurator_system.png|650px]]}}}
{{{foto|[[Image:FMA2_Configurator_system.png|650px]]}}}
==Static Navigation Mode==
Static Navigation Mode is a filter, which filters out track jumps when the object is stationary. If Static navigation filter is disabled, it will apply no changes on GPS data. If Static navigation filter is enabled, it will filter changes in GPS position if no movement is detected (depends on Object Motion Detection Settings). It allows filtering GPS jumps when object is parked (is not moving) and GPS position is still traced.<br/>
==Automatic Ignition detection:==
*When device starts, it determines voltage system it is plugged in. It is done by checking external power voltage - if voltage is between 5 - 8 V, it is 6 V system (ignition is on when power voltage is between 6,1 - 8 V). If voltage is between 8 - 16 V, it is 12 V system (ignition is on when voltage is between 13,2 – 16 V). If voltage is between 16 - 32 V, it is 24 V system ( ignition is detected when voltage is between 27 – 32 V).<br/>
*If ignition was determined as ON and voltage dropped below the stated threshold, then device starts counting a configured timeout. Only after timeout runs out ignition is determined to be at OFF state. If power voltage goes back to high level before timeout runs out, ignition state should not change.
