Line 11: |
Line 11: |
| =='''How to insert Micro-SIM card'''== | | =='''How to insert Micro-SIM card'''== |
| | | |
− | *Insert Micro-SIM card as shown with PIN request disabled or
| + | # Gently remove {{{model|FMB9YX}}} '''cover''' using '''plastic pry tool''' from both sides. |
− | read our Wiki how to enter PIN later in Teltonika | + | # Insert '''{{{sim_type|Micro-}}}SIM''' card as shown with '''PIN request disabled''' or read {{{sim_pin|[[FMB900 Security info|'''Security info''']]}}} how to enter it later in Configurator. Make sure that {{{sim_type|Micro-}}}SIM card '''cut-off corner''' is pointing forward to slot. |
− | Configurator. Make sure that Micro-SIM card cut-off corner is | + | # Attach device '''cover''' back. |
− | pointing forward to slot. | + | # Device is ready to be connected. |
− | *Connect battery as shown to device.
| |
− | *Connect micro usb cable as shown
| |
− | *To power up TST100, connect green plug to the E-scooter
| |
− | *Open Teltonika configurator, select TST100 device and
| |
− | configure it according to your requirements (how to install
| |
− | drives on page
| |
− | *Once all done, disconnect TST100 from PC and E-scooter. Attach
| |
− | the lid by two screws as shown
| |
| | | |
| [[Image:Fmb920_cover_1.png|280px]][[Image:Fmb920_cover_2.png|280px]][[Image:Fmb920_cover_3.png|280px]][[Image:Fmb920_cover_4.png|280px]] | | [[Image:Fmb920_cover_1.png|280px]][[Image:Fmb920_cover_2.png|280px]][[Image:Fmb920_cover_3.png|280px]][[Image:Fmb920_cover_4.png|280px]] |