Changes

==Deep Sleep mode==

==Deep Sleep mode==

While in deep sleep mode, {{{model|FMB1YX}}} sets the GNSS receiver to sleep mode and turns off GSM/GPRS module (hence it is not possible to wake up device via SMS). Despite records with last known coordinate being saved and sent to AVL server (GSM/GPRS module is turned on to send data and then it is turned off), power usage is decreased to save vehicle's battery. Please note that power saving depends on two configurable parameters: ''Send Period'' and ''Minimum Record Saving Period'' in "X on Stop Mode". When records are sent successfully in deep sleep mode, open link timeout counter will be skipped and {{{model|FMB1YX}}} will enter deep sleep mode immediately.<br/>Because a lot of functions are disabled in deep sleep mode following I/O elements are disabled from records that are generated in this mode: GSM Signal, GNSS Status, GNSS PDOP, GNSS HDOP, GSM CellID, GSM Area Code, Active GSM Operator{{{txt_IO|, Trip Odometer, Total Odometer, Speed, Fuel Rate GPS, Fuel Used GPS}}} and ICCID.

While in deep sleep mode, {{{model|FMM6YX}}} sets the GNSS receiver to sleep mode and turns off GSM/GPRS module (hence it is not possible to wake up device via SMS). Despite records with last known coordinate being saved and sent to AVL server (GSM/GPRS module is turned on to send data and then it is turned off), power usage is decreased to save vehicle's battery. Please note that power saving depends on two configurable parameters: ''Send Period'' and ''Minimum Record Saving Period'' in "X on Stop Mode". When records are sent successfully in deep sleep mode, open link timeout counter will be skipped and {{{model|FMM6YX}}} will enter deep sleep mode immediately.<br/>Because a lot of functions are disabled in deep sleep mode following I/O elements are disabled from records that are generated in this mode: GSM Signal, GNSS Status, GNSS PDOP, GNSS HDOP, GSM CellID, GSM Area Code, Active GSM Operator{{{txt_IO|, Trip Odometer, Total Odometer, Speed, Fuel Rate GPS, Fuel Used GPS}}} and ICCID.

{{{model|FMB1YX}}} can enter deep sleep mode if ALL of these conditions are met:

{{{model|FMM6YX}}} can enter deep sleep mode if ALL of these conditions are met:

* {{{model|FMB1YX}}} is configured in Deep Sleep mode and sleep timeout is reached;

* {{{model|FMM6YX}}} is configured in Deep Sleep mode and sleep timeout is reached;

* Device time must be synchronized with GPS satellites. From Firmware 03.18.15 version, this condition depends on “Records saving/sending without TS” parameter:

* Device time must be synchronized with GPS satellites. From Firmware 03.18.15 version, this condition depends on “Records saving/sending without TS” parameter:

:* After Position Fix - {{{model|FMB1YX}}} time is synchronized with GNSS satellites and GPS fix is obtained;

:* After Position Fix - {{{model|FMM6YX}}} time is synchronized with GNSS satellites and GPS fix is obtained;

:* After Time Sync - {{{model|FMB1YX}}} time is synchronized over NTP, NITZ or GNSS satellites;

:* After Time Sync - {{{model|FMM6YX}}} time is synchronized over NTP, NITZ or GNSS satellites;

:* Always - {{{model|FMB1YX}}} will enter sleep mode without time synchronization and GPS fix.

:* Always - {{{model|FMM6YX}}} will enter sleep mode without time synchronization and GPS fix.

{{{txt_ignition|* Ignition (configured ignition source) is off;}}}

{{{txt_ignition|* Ignition (configured ignition source) is off;}}}

* Movement is not detected by the accelerometer{{{txt_movement| or configured movement source}}};

* Movement is not detected by the accelerometer{{{txt_movement| or configured movement source}}};

* ''Min. Record Saving Period'' ({{{ctrDaq|[[{{{model|FMB1YX}}} Data acquisition settings|Data Acquisition Mode settings]]}}}) must be larger than ''Open Link Timeout'' parameter, so that {{{model|FMB1YX}}} could close GPRS link;

* ''Min. Record Saving Period'' ({{{ctrDaq|[[{{{model|FMM6YX}}} Data acquisition settings|Data Acquisition Mode settings]]}}}) must be larger than ''Open Link Timeout'' parameter, so that {{{model|FMM6YX}}} could close GPRS link;

* The difference between ''Send Period'' ({{{ctrDaq|[[{{{model|FMB1YX}}} Data acquisition settings|Data Acquisition Mode settings]]}}}) and ''Open Link Timeout'' must be more than 90 seconds, so that {{{model|FMB1YX}}} could close GPRS link within at least 90 seconds;

* The difference between ''Send Period'' ({{{ctrDaq|[[{{{model|FMM6YX}}} Data acquisition settings|Data Acquisition Mode settings]]}}}) and ''Open Link Timeout'' must be more than 90 seconds, so that {{{model|FMM6YX}}} could close GPRS link within at least 90 seconds;

* There are no SMS messages being received;

* There are no SMS messages being received;

* Data socket(s) are closed;

* Data socket(s) are closed;

{{{usb_disconnected|}}}  

{{{usb_disconnected|}}}  

{{{model|FMB1YX}}} exits deep sleep mode if {{{txt_exit|ONE of following conditions}}} is true:

{{{model|FMM6YX}}} exits deep sleep mode if {{{txt_exit|ONE of following conditions}}} is true:

* Movement by accelerometer{{{txt_movement| or configured movement source}}} is detected;

* Movement by accelerometer{{{txt_movement| or configured movement source}}} is detected;

{{{txt_ignition|* Ignition (configured ignition source) is turned on.}}}

{{{txt_ignition|* Ignition (configured ignition source) is turned on.}}}